Within a gaseous cloud of atoms, there is a distribution of velocities. This distribution depends on the temperature and mass of the atoms. The distribution of velocities in the direction of the laser beam, which is known as the Maxwell-Boltzmann velocity distribution, is shown by the blue line in Fig. 1 The Maxwell-Boltzmann velocity distribution often uses the function f (v) to represent the distribution of velocities. This is not the f we use for frequency. A good rule of thumb is that if it is a function, like f (v), the “f ” is probably referring to a distribution. If the “f ” is all by itself in a formula, it is probably referring to a frequency.

Fig. 1A cloud of gaseous atoms will have a distribution of velocities given by this graph. This distribution, which is derived from thermodynamics, is known as the Maxwell-Boltzmann velocity distribution.
The full width at half maximum of a Maxwell-Boltzmann velocity distribution, which is a velocity with units m/s, is:

where kB = 1.38×10−23 J/K is the Boltzmann constant, T is the temperature of the gas (the unit is kelvin), and m is the mass of an atom in the gas (the unit is kilogram). The hotter the gas, the wider the velocity distribution, and thus the larger the average speed of the atoms in the gas. The mass of an atom is in the denominator, so atoms with larger masses have smaller average speeds compared to an equally hot gas of smaller mass atoms.
How to Use Distributions This section isn’t really needed to understand the velocity distribution. However, distributions are incredibly important in many areas of science, so I wanted to spend a bit of time talking about how we use them. The velocity distribution represents the fraction of atoms that fall within a particular velocity range. Since an atom must have some velocity, the total area under the curve in Fig. 1 is 1. This is equivalent to saying that each atom must have some velocity between
and
.
To use a distribution, you ask questions like, “What fraction of atoms have a positive parallel velocity component?”, “What fraction of atoms have a parallel velocity component between −2 and 10 m/s?”, or more generally, “What fraction of atoms have a parallel velocity component between
and
?”, where va and
are any velocities we choose.
The answer is the area under the distribution between
and vb. If we want to know the total number of atoms from the sample that have velocity components between those two values, we multiply that fraction by the total number of atoms in the sample. For example, here are three plots with different choices of
and
:

Suppose we have 5000 atoms in our sample. As shown in the first plot, there are 5000 × 0.726 = 3630 atoms with parallel velocity components between
= −100 m/s and
=+200 m/s. As shown in the second plot, there are 5000 × 0.061 = 305 atoms with parallel velocity components between
=−200 m/s and
=−150 m/s, and in the third plot there are 5000 × 0.347 = 1735 atoms with parallel velocity components larger than 50 m/s.

Fig.2 A comparison between a Gaussian function and a Lorentzian function. Each function has an area under the curve of 1 and a FWHM of 1.
The mathematical function that describes the shape of the Maxwell-Boltzmann velocity distribution is a Gaussian function given by:

A Gaussian looks similar to the Lorentzian function that models the shape of a spectral feature, but the two functions are different. Figure 2 shows a plot of both a Gaussian function and a Lorentzian function with the same area and FWHM. Notice the Lorentzian has larger “tails” and is more spread out compared to the Gaussian function. Both functions are very common in physics and math.
Extra Math for Those Who Have Taken Statistics In statistics, Gaussian functions are written as
where σ is called the standard deviation. For the Maxwell-Boltzmann velocity distribution, the standard deviation is
The FWHM of a Gaussian function defined using the standard deviation is:
(1)