High-performance liquid chromatography
High-performance liquid chromatography provides a very convenient method of purification, particularly if gas chromatography is either inapplicable or if derivatisation of the compound is necessary to enable chromato graphic separation. Unlike gas chromatographs, liquid chromatographs are usually operated at or only slightly above ambient temperature, and detectors such as UV-visible and diode-array detection are nondestructive. Thus, the appropriate fraction of eluate can be collected by holding a test-tube or vial under the exit port as the substance of interest elutes. This can either be done via knowledge of the time at which the substance elutes or by monitoring the detector response and collecting the sample as the peak inflection starts.
The method used to retrieve the sample from the eluate to present to the IR spectrometer depends upon whether the compound is a solid or a liquid and, if the latter, on its volatility and the quantity present. All the common solvents absorb in the IR region. However, with the data processing facilities of modern IR spectrometers, this is not a great disadvantage. The spectrum of the solvent can be recorded and then subtracted from the combined spectra of the compound and solvent to give a difference spectrum. If the concentration of the sample is low, the difference spectrum can be enhanced either by repetitive scanning and signal averaging or by expansion of the ordinate scale. In many cases, however, the amount of material is too small to enable the compound to be collected and transferred to standard cells.
Alternatively, the compound can be recovered by evaporation of the solvent. However, evaporation also concentrates any nonvolatile impurities in the solvent, so the use of pure solvents is essential. Another possible source of contamination is the packing material used in liquid chromatography columns. Many of these materials are based on silica gel and appreciable amounts of silica may be dissolved by certain solvents. Collecting from reversed-phase HPLC can be more difficult owing to the presence of water from the mobile phase, particularly where this will cause problems with spectral interpretation. Evaporation of water requires heating of the sample, which may lead to solute degradation or loss by volatilisation.